Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

high power SPST for X band help

Status
Not open for further replies.
E

eladg

Full Member level 3
Joined
Jan 13, 2002
Messages
185
Helped
7
Reputation
12
Reaction score
3
Trophy points
1,298
Activity points
1,237
I need to design a single stage SPST switch (Isolation of 20 dB minimum, cold switching) for the following conditions:
P=1000W, PW=100uS, DC=10% at X-band (BW=10%).
i took a few kind of diode in paralel, But the matching is very sensitive to the capacitance variation.

can some one help me ?

B.R.
eladg
 

Yeah, that is a tough one. However, the average power is not too bad. There are ways of doing it, but those are the secrets of the trade. Would be happy to design it for you.
 

biff44 said:
Yeah, that is a tough one. However, the average power is not too bad. There are ways of doing it, but those are the secrets of the trade. Would be happy to design it for you.
Click to expand...
thank, but the pulse width is to mlong to use an average power. the heat is olmost like cw

best regards eladg
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top