Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

High freq EMC filter.

Status
Not open for further replies.

treitmey

Member level 1
Joined
Jan 22, 2008
Messages
38
Helped
4
Reputation
8
Reaction score
0
Trophy points
1,286
Activity points
1,510
My latest product went to EMC testing and failed miserably. I run the circuit from 115VAC and a long cord. I will test soon, but my gut says that the noise is comming in on the 115. Has anyone built a circuit(filter) for such a problem? The EMC high freq test is a steel plate driven by a sparking (high power) high freq(>1MHz) noise. I communicate across the 115 and need the low pass filter knee to be around 5KHz. (5k-200k)

I can plunk the values into a calculator and get a filter. But I wanted to know if someone with experience has solved this problem already?

Thank you for your help. Tim
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top