HFSS object movement issue

[Rf engineer]

hi,

i have created an object and performed some subtraction operation on the geometry......

now when i change the position of the modified project........it do not shows the updated subtracted object on the new position.....rather is shows......the unsubtracted initial object.......

so plz help me..........out....

thx

 

[smsdkl]

i previously faced the same problem once

In hfss when u cut an object then move it only the original object moves.
to solve this problem
while u r designing the original object and the cutset part use variables to assign the starting coordinates where the coordinates of the cut object are in some relation to the coordinates of the original object.
This should solve your problem

if u still face any problems pm me.