Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] HFSS error in microstrip line simulation: Port refinement, process abcd3 died

Status
Not open for further replies.

Radike

Member level 3
Joined
Aug 24, 2008
Messages
58
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,286
Activity points
1,722
Hi,
I am using HFSS version 9 and I am new to HFSS. I am in the process of simulating a microstrip line. I am getting this error saying "Port refinement, process abcd3 died unexpectedly" This happens when I increse my modes in port 2 up to 5. It works until 4 modes. Can an expert explain me regarding this?

:|:|Thanks!!
 

shameemkabir

Full Member level 4
Joined
Oct 31, 2007
Messages
238
Helped
48
Reputation
98
Reaction score
18
Trophy points
1,298
Activity points
2,623
Re: HFSS Error

I'm not sure. Are you sure your setup frequency supports 5 modes? If not, increase the setup frequency.
 

Radike

Member level 3
Joined
Aug 24, 2008
Messages
58
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,286
Activity points
1,722
Re: HFSS Error

Hi,
Thanks for the reply. I chenged the dimensions of the ports. Now I can go up to 5 modes. Not sure why it is so.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top