Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

HFSS 3D Layout - How delete bump/ball w/o deleting the pin?

Status
Not open for further replies.

farhill

Newbie level 5
Joined
May 25, 2009
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,330
In HFSS 3D Layout, when you configure the device (die, BGA) as say, flip chip, the bump/ball will auto grow to each pin/pad. Now we need to delete the bumps attached to all non-port pin/pad to avoid shortcircuit. But in 3D Layout when selecting a bump/ball, the whole pin is selected. How to only delete bump/ball but reserve the pin/pad?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top