Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Hercules DRC error: PO.RL.1: ALLPOLY maximum length = 200000nm (after poly_sub cut)

Status
Not open for further replies.
S

shavakmm

Member level 4
Member level 4
Joined
Oct 6, 2007
Messages
75
Helped
9
Reputation
18
Reaction score
6
Trophy points
1,288
Location
Bangalore
Activity points
1,705
I am getting below error in Hercules DRC run. Can anybody explain about this error and also how to solve this?

PO.RL.1: ALLPOLY maximum length = 200000nm (after poly_sub cut)
... 2 violations found

ERROR DETAILS



#####--- ERR_SELECT -----------------------------------

SELECT_CONTAINS ALLPOLY_CUT {
COMMENT = "PO.RL.1: ALLPOLY maximum length = 200000nm (after poly_sub cut)"
WIDTH=200.0001
HEIGHT=0.0001 } (320;19)

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Structure ( lower left x, y ) ( upper right x, y )
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
XYZ_TOP (401.536, 2.160) (401.572, 333.540)
XYZ_TOP (401.654, 2.160) (401.690, 333.540)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top