Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help! The results comparison b/w ACS and DC Ultra

Status
Not open for further replies.

johnli100

Member level 1
Joined
Apr 13, 2004
Messages
32
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
243
Dear all,

Recently I am trying to synthesis a large module with both Automated Chip Synthesis (ACS) method and traditional top2down DC Ultra method. Then, I compared the synthesis results for both two methods. I found the ACS gives a very large area report, say 70% more than top2down DC Ultra result!!

In fact, the ACS procedure should also call the DC Ultra license, how come the result shows so large different? What is the possible result that my ACS generate a poor result?

Wait 4 help!
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top