neazoi
Advanced Member level 6
Hello, I have a problem with a project and the creator has suggested that this might a problem with the fuses.
His response is shown below.
Could you please tell me how can I set the fuses?
at the first look I thik this could be a fuse problem. Without setting
the fuses, the controller will run mostly at 8 MHz RC oscillator
divided by 8 (1 MHz). The correct settings will be found unfortunately
only at the documentation of the 0.35 version:
ATMega 88:
- ----------
LOW 0xe6
HIGH 0xd4
His response is shown below.
Could you please tell me how can I set the fuses?
at the first look I thik this could be a fuse problem. Without setting
the fuses, the controller will run mostly at 8 MHz RC oscillator
divided by 8 (1 MHz). The correct settings will be found unfortunately
only at the documentation of the 0.35 version:
ATMega 88:
- ----------
LOW 0xe6
HIGH 0xd4