Jun 8, 2005 #1 girish_wabale Member level 3 Joined Mar 21, 2005 Messages 66 Helped 7 Reputation 14 Reaction score 2 Trophy points 1,288 Location Pune Activity points 1,861 Hi I am new in ARM I am using keil MCB 2100 board which uses LPC2129 I want to read the contents from ADC but I was not able to do it? Can anybody help me I have read ADDR but it never gives me converted value What is the configuration for burst mode and s/w controlled mode Please give me detail explaination. Thanks in Advance
Hi I am new in ARM I am using keil MCB 2100 board which uses LPC2129 I want to read the contents from ADC but I was not able to do it? Can anybody help me I have read ADDR but it never gives me converted value What is the configuration for burst mode and s/w controlled mode Please give me detail explaination. Thanks in Advance
Jun 8, 2005 #2 V vdaniel Full Member level 4 Joined Oct 8, 2004 Messages 204 Helped 8 Reputation 16 Reaction score 0 Trophy points 1,296 Activity points 2,157 Re: Need Help on ARM With the Keil MCB2100 comes CD (you can download it free from www.keil.com), with a lot of examples. If you install the Keil, then go to: c:\Keil\ARM\Boards\Keil\MCB2100 and run the Blinky project. You will find there code for the ADC reading. Varuzhan
Re: Need Help on ARM With the Keil MCB2100 comes CD (you can download it free from www.keil.com), with a lot of examples. If you install the Keil, then go to: c:\Keil\ARM\Boards\Keil\MCB2100 and run the Blinky project. You will find there code for the ADC reading. Varuzhan
Jun 10, 2005 #3 girish_wabale Member level 3 Joined Mar 21, 2005 Messages 66 Helped 7 Reputation 14 Reaction score 2 Trophy points 1,288 Location Pune Activity points 1,861 Re: Need Help on ARM on keil webside only one example about ADC is given and that is in C I want examples of h/w mode and software control mode in assembly Also I am not able to understand ADCR ADDR reg 's from users manual can enybody help me
Re: Need Help on ARM on keil webside only one example about ADC is given and that is in C I want examples of h/w mode and software control mode in assembly Also I am not able to understand ADCR ADDR reg 's from users manual can enybody help me