Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help me choose conformal coating method for SMT double-sided PCB

Status
Not open for further replies.

me_guitarist

Full Member level 6
Joined
Oct 3, 2006
Messages
338
Helped
0
Reputation
0
Reaction score
0
Trophy points
16
Location
Malaysia
Activity points
0
i Have a SMT double sided pcb that require conformal coating.

The problem is top side we have a thermostat that coating is not require. Bottom side we have terminal block that doesn't require coating as well.
Board size around 1 1/2"x 1".

Any suggestion which method is suitable?

1. Brush
2. Spray
3. Drip

Thanks in advance
 

Re: Conformal Coating

Try to mask the portions where you don't need conformal coating with ,say, wax flow. then apply conformal coating. after dry try to remove the waxed portions carefully and then clean the section.
Sarma
 

Re: Conformal Coating

i meant a smear of bees wax ( even vaseline/white petroleum jelly will do)in the locations where you don't want conformal coating to catch. after the coat is over a careful cleaning of wanted areas will remove conformal cating as it is over a greasy surface.

Sarma
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top