Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help me build a cheap cell phone jammer

Status
Not open for further replies.

tridoshanjay jain

Newbie level 1
Joined
Sep 20, 2007
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,294
hi i m tridoshanjay jain .............
i want to make a cell phone jammer in as much as low cost...
i want circuit diag. of it........
pls help...
 

Re: cell phone jammer

well i don't have the diagram but i can provide you some idea...
well our cell phones operate on 1800-2400 Mhz Career band...so if you just make a circuit which would osciate an produce frequencies between 1800 and 2400 Mhz then the signals from the service provider will not be accepted by the cellphone as your signals will have a stronger power (for a specific area), and this will now allow any other same frequency career to reach near.

Best Regards
 

Re: cell phone jammer

you need an old phone and unlock its pll
then strobe up and down the freq output on tx
so jam tx carrier then add 1khz dtmf tone
and ramp up and down as fast as possible

better is an electric motor of a type for jamming radio

has brushes on its armiture rotor cylinder
fixed magnets and coils

the brushes move round the inside of the cylinder and the cylinder has various sizes of ducts on it
the brushes just give sparks

the brushes are made from nickel the whole cylinder is made from brass

and add an antenna to the outer jacket cylinder
 
Re: cell phone jammer

And check what else it knocks out, and whether it's actually legal to use in your location....
 

cell phone jammer

what a very good suggestions............. i wish i had those ideas......... go to google type in schematic diagram of cellphone jammer then you'll have alot of places to look in.....
 

cell phone jammer

hope this will help
h**p://www.ladyada.net/make/wavebubble/
*=t
 

Re: cell phone jammer

check this

Added after 6 minutes:

there are some designs
 

Re: cell phone jammer

Hi

Just open the web link

**broken link removed**

all the best dear

Added after 17 minutes:

Hi again

Here the circuit dear
 

cell phone jammer

there is many links and file attachement ,search JAMMER in the forum
 

Re: cell phone jammer

I don't know which country you are in, but it is illegal to use cell phone jammer in USA.
 

Re: cell phone jammer

i have a project on GSM jammer which i would like to sell....
it works perfectly fine for GSM networks and i haven't tested CDMA networks on it...
if anyone from mumbai is interested in buying it can mail me at hallowed_be_thy_name_11(at)yahoo.co.in

Added after 2 minutes:

i have a project on GSM jammer which i would like to sell....
it works perfectly fine for GSM networks and i haven't tested CDMA networks on it...
if anyone from mumbai is interested in buying it can mail me at hallowed_be_thy_name_11(at)yahoo.co.in

Added after 50 seconds:

i have a project on GSM jammer which i would like to sell....
it works perfectly fine for GSM networks and i haven't tested CDMA networks on it...
if anyone from mumbai is interested in buying it can mail me at hallowed_be_thy_name_11(at)yahoo.co.in
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top