Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HELP LPT port on ECP mode????

Status
Not open for further replies.

hbaocr

Full Member level 4
Joined
May 13, 2007
Messages
235
Helped
25
Reputation
48
Reaction score
5
Trophy points
1,298
Location
Hochiminh City university of technology (VietNam)
Activity points
2,776
ecp mode programming

HEllo;
plz help me,
how to input data from peripheral device to my PC through LPT port on ECP mode (use bidirection data).
If U don't mind , plZ send me some Visual Basic code to control LPT port , and receive signal form that port on ECP mode and display recieved value from peripheral device on your form using inpout32.dll
thank
 

hbaocr

Full Member level 4
Joined
May 13, 2007
Messages
235
Helped
25
Reputation
48
Reaction score
5
Trophy points
1,298
Location
Hochiminh City university of technology (VietNam)
Activity points
2,776
how to set lpt in ecp mode

Thank, but i need more detail about it. such as
how to input signal to PC through LPT in ECP mode
how to setup LPT in ECP mode ( parallel input 8 bit)
how to get it from ECR register to use for my program.
And what is the input address when i use ECP mode.(8 bit parallel) ex: to get received data inp(Addrin) so what value of Addrin is in this mode ecp use 8 bit data to input (bidirection bit)
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top