Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Help-- full wave rectifier on PSPICE design

Status
Not open for further replies.

mohit571

Newbie level 4
Joined
Mar 14, 2010
Messages
6
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
New Delhi, India, India
Activity points
1,328
Hi,

I have designed a full wave rectifier on CAPTURE on Pspice 16.3v with non linear load, but all ends show zero volt and zero amp. also while compiling it shows " No pspice template for < > , ignoring.




Pls suggest me...!!
 

Attachments

  • design.doc
    94.1 KB · Views: 102

"No PSpice template" means what it says, you are probably using schematic symbols that aren't taken from the PSpice specific component library.

Before designing a simulation circuit from the scratch with Orcad capture, you should start with something more simple, e.g. opening and modifying one of the examples shipped with Pspice. Learn about the simulation related component attributes and how Spice models are linked to the component.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top