selvan0201
Junior Member level 1
Hi to everyone. I was new to this area just familiar with Aduc-841 but not much more about DDS. I had studied the datasheet of AD9834 but still I have some programming doubts. First of all I would tell what I had done in this project.
1. SPI interfacing done with ADUC – 841.
2. A digital POT is connected to the microcontroller to vary the amplitude of the given signal.
3. Microcontroller clock is 11.0592 MHz
4. Master clock is 40.00MHz
Problems I can’t understand are:
1. How to calculate the frequency using the Mclk.
Any help will be high valued to complete my project.
1. SPI interfacing done with ADUC – 841.
2. A digital POT is connected to the microcontroller to vary the amplitude of the given signal.
3. Microcontroller clock is 11.0592 MHz
4. Master clock is 40.00MHz
Problems I can’t understand are:
1. How to calculate the frequency using the Mclk.
Any help will be high valued to complete my project.