Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help! (digital sigma Delta DAC in Cadence)

Status
Not open for further replies.

nishagajare

Junior Member level 1
Joined
Feb 5, 2013
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,389
Hello all!!! I have designed digital sigma Delta DAC in Cadence. At the output designing analog sallen and key low pass filter but problem to recover the signal.i need to change the desinged components value to match with signal.
Still not getting properly. Could you please tell me what exactly the problem with my filter
 

Post a schematic and design goals of the filter so forum can help you.

Regards, Dana.
 

Thank you so much for response
Input signal frequency 23 khz
Osr value of 10
Bw is 1.6Mhz
Expected to recover input signal with same bandwidth
schematicinpit bits are 8 bits and Output is one bit digital pwm signal applied to one bit dac then sallen and key low pass filter 4 th order but not getting proper signal recovered but if I try to change components value is going to match with input signal , not getting logic
Here I attached the schematic
 

Attachments

  • 1604581552157..jpg
    1604581552157..jpg
    701 KB · Views: 81

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top