Has anybody worked with TSH300 opamp ?

Status
Not open for further replies.
E

elecrom

Junior Member level 3
Joined
Sep 24, 2007
Messages
25
Helped
3
Reputation
6
Reaction score
1
Trophy points
1,283
Location
Kharagpur
Activity points
1,472
Hello,

Has anybody used TSH300 ?

I have built very simple non-inverting opamp ckt with gain of 20 on a PCB.

Somehow it is not working.

Power Supply : +-5V

Input:
10MHz, 50mv rms

Problem :
- Output is clamped to : -5V
- TSH300 draws almost 100mA from -ve supply rail, while current drawn from +ve rail is 20mA. And also IC becomes hot.

What could go wrong in such a simple circuit ?
 

According to the datasheet, maximum supply voltage is 6V. It may have been damaged by the +/- 5V supply or hopefully doesn't operate temporary.
 

Is it ? I think is 6V on VCC and -6V on -ve VCC pin.
 

After i check the spec, find that there are two packages with different pin assignment for TSH300.
So, would u use the SOT23-5 or SO8 ?
It is only correct by using SOT23-5 in ur circuit diagram.
 

Hmm ...

I had somehow missed that footnote on page 2 of datasheet. Thanks for pointing it out.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…