indiantuktuk
Newbie level 6
- Joined
- Apr 30, 2009
- Messages
- 11
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- Bangalore, India
- Activity points
- 1,356
Hi,
I would wish to use the above mentioned optocoupler to sense / transmit the error signal to the controller.
The detector operating voltage range is from 0V to 15V
The error signal is of 15V (connected to Pin1:anode) thru 1.3K resistor pull up and Vcc is 3.3V (connected to pin 6).
The requirement is to have 3.3V output signal.
Query: whether the optocoupler would perform or just burn off?. Please suggest any improvement.
Thx
I would wish to use the above mentioned optocoupler to sense / transmit the error signal to the controller.
The detector operating voltage range is from 0V to 15V
The error signal is of 15V (connected to Pin1:anode) thru 1.3K resistor pull up and Vcc is 3.3V (connected to pin 6).
The requirement is to have 3.3V output signal.
Query: whether the optocoupler would perform or just burn off?. Please suggest any improvement.
Thx
