Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
are you able to flash the ELF file onto lpc2129 using the device or you get while loading the executable or during running....
have youmade proper settings in keil to identify the Jtag device?????????
explain clearly what you have done till now and
when, and at what step you get this error........
hi,
ckshivaram
i am using lpc 2129 board ,HJTAG,KEIL UV3,
i able to flash hex file using h-jtag,Flasher and RDI interface, JLINK but while debugging in keil uv3 i got these errors i e
please check the following setting in the options for target..
debug tab:
1. you have select 2 columns with radio buttons like "Use simulator" and use {a box where you have to select your debugger) ,select " proper debugger by using drop down window.
2. the you have load application at startup and go till main, select the 1st one, and try to select go till main as next option if everything fails....
3. restore debug session settings: se;lect all the boxes.
4. driver DLL: SARM.dll parameter: leave it blank
5. Dialog DLL: TARMP.dll parameter: -pLPC21xx
next select utilities tab and select first option "Use target driver for flash programming" and select your debugger and try
hi,
thank you your response to me.........
in debug tab:
1) i have selected only one use(RDI interface driver)
and followed your 2,3,4 steps .......
then also after debugging step i am getting these errors..
please help me to over come these followings...
To download program into FLASH, you need to configure H-JTAG and H-Flasher properly.
1 - In H-JTAG, enable Flasher -> Auto download
2 - In H-Flasher, select LPC2129 in the flash list;
3 - In keil, disable the use of flash loader.
Please try again as follows:
1 - Ensure that your program is located in the flash address range.
2 - In H-Jtag, enable the auto download option;
3 - In H-Flasher, select the right chip and don't perform any other operations.
4 - In Keil, please choose download app at startup and uncheck run to main
also try to debug the program in the keil simulator and see if it works or throws the same error while debugging on simulator,..........
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.