eda_
Newbie level 2
Hello
I use simcom 900D GPRS module and Arduino Uno board. I can send data to my PC but I dont know how to get data to my Arduino board over GPRS from the PC.
does the module have to be in transparent mode ? (if so which format should I use to send AT command to GPRS from my PC application to get into transparent mode)
or is there another way to send command to MCU. (for example lets say I want to make one output high by sendind command from PC)
should I use FTP operation ?
Thanks
PS : I have searched but nothing found about this .
I use simcom 900D GPRS module and Arduino Uno board. I can send data to my PC but I dont know how to get data to my Arduino board over GPRS from the PC.
does the module have to be in transparent mode ? (if so which format should I use to send AT command to GPRS from my PC application to get into transparent mode)
or is there another way to send command to MCU. (for example lets say I want to make one output high by sendind command from PC)
should I use FTP operation ?
Thanks
PS : I have searched but nothing found about this .