Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

general EMC rules to route micro wires

Status
Not open for further replies.

mkbs

Member level 3
Joined
Apr 10, 2003
Messages
67
Helped
4
Reputation
8
Reaction score
2
Trophy points
1,288
Activity points
626
General EMC rules

Hi,
I'd like to know some general EMC rules to route micro wires , ( like reset circuit and so on...), to route a pcb with the smallest number of errors.
Thanks.:wink:
mkbs 8) 8)
 

flatulent

Advanced Member level 5
Joined
Jul 19, 2002
Messages
4,629
Helped
489
Reputation
980
Reaction score
150
Trophy points
1,343
Location
Middle Earth
Activity points
46,689
try this

1. Place the highest frequency components in the center of the board.

2. Have the power planes not come out flush with the ground planes. Recess them by at least 2x the layer spacing. Stitch the ground planes togther around the edges of the boards with vias.

3. Have a symetric stack up layer of ground and power with respect to the center of the board.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top