gang programming for 8051

Status
Not open for further replies.
Standard 8051 is a ROM-less device, so what would you like to program there?
However, if you consider ROM/EPROM version of the 8051, namely 8751 (in various versions with OTP, EPROM ...), you can use single programmer's circuit and connect several units in parallel. The only difference will be that you will have make sure that each of the programmed devices has sufficient power supply and that each address/data lines can drive numbers of MCUs.
Regards,
IanP
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…