Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

FPGA tools- sending/receving data through USB-JTAG interface

Status
Not open for further replies.

saeeed

Newbie level 2
Joined
Sep 7, 2007
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,292
FPGA interface tools

SA
Hello everybody
i need tool (matlab, labview, .....) to help me in sending/Receving data from/to computer to/from FPGA board (Virtex II Pro). BUT through the USB-JTAG interface only.

The situation is like that: the FPGA board is the channel of certain communication system. i need to send the modulated data from computer to that channel. then, receiving it again to computer. i need NOT to use serial port or any interface except USB-JTAG.
 

Marcel Majoor

Full Member level 2
Joined
Jan 17, 2004
Messages
148
Helped
69
Reputation
138
Reaction score
39
Trophy points
1,308
Activity points
1,569
Re: FPGA interface tools

If it is during development that you need to communicate, then use MathWorks MatLab Simulink with System Generator. Then use 'hardware-in-the-loop'.
Some document about this:
**broken link removed**
 

saeeed

Newbie level 2
Joined
Sep 7, 2007
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,292
Re: FPGA interface tools

thanks dear. i'll try it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top