Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Can anybody tell me how flying probe test is done on a PCB for detecting short. Will they apply some voltage between supply pin and ground and measure current?
Of course engineers design and determine what points are tested, with which voltage, and what current, results are monitored. Also capacitance, resistance, inductance can be monitored on determined points. Flying probe also check placement of parts and their locations on pcb. All of this summarized and PCB on end get Pass mark or Failed!
What flying probe can do depends from manufacturer model and cost!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
