Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What is the most common way of extracting the flatband and threshold voltage of a MOS capacitor in Silvaco? (Either using the C-V measurement capability or not)
You can extract a CV curve using ATLAS and sweeping the voltage and defining the steps. You could then consider plotting 1/C^2 vs voltage to extract the threshold voltage.
Alternatively both ATLAS and ATHENA allow you to extract the VT voltage directly, which you could also conduct for comparison.
Finally, I assume you have calculated the analytical value for VT to check all three are in close agreement.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.