Blue_Electrons
Newbie level 2
Hello,
I'm currently designing a Patterned (w/ Slots) Marchand Balun to increase the Even/Odd Impedance Ratio for good balance.
LineCalc is able to simulate Zoe and Zoo given the width and spacing of a coupled lines but it assumes an infinite ground plane.
However, for the patterned ground plane, the LineCalc would not be applicable. Any idea on how to simulate this using ADS?
I'm currently designing a Patterned (w/ Slots) Marchand Balun to increase the Even/Odd Impedance Ratio for good balance.
LineCalc is able to simulate Zoe and Zoo given the width and spacing of a coupled lines but it assumes an infinite ground plane.
However, for the patterned ground plane, the LineCalc would not be applicable. Any idea on how to simulate this using ADS?