Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Ethernet Transformer

Status
Not open for further replies.
F

FreshmanNewbie

Full Member level 6
Joined
May 10, 2020
Messages
386
Helped
0
Reputation
0
Reaction score
2
Trophy points
18
Activity points
3,857
Can someone tell me what is the meaning of Open circuit inductance and why we need to take care while choosing magnetics?

Also I have seen that, the turns ratio for selecting magnetics is 1:1 and must be 350uH. Can someone tell why is this value of 350uH is recommended? Can we increase or decrease this inductance value?
 

Sort by date Sort by votes
Transformer inductance requirements can be derived from 10BASE-T load specification, e.g. in IEEE 802.3 clause 14. Higher inductance would be no problem as such, lower inductance can be extected to cause a violation of the waveform mask.
 

Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top