Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

estimating the area to fabricate the layout of an inductor

Status
Not open for further replies.
K

ksooryakrishna1

Member level 2
Joined
Apr 8, 2008
Messages
51
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,563
How to estimate the area

I would like to know how to do the rough estimate of the required area to fabricate the layout of a inductor. Requesting to attach some materials regarding this. thanks in advance.
 

Re: How to estimate the area

This will depend on the design rules for the top (thick) metal.
Since you will know the number of turns, the area will depend on minimum spacing and line width of metal used. From there it is a simple calculation.
 

Re: How to estimate the area

Could you tell from where i can get the necessary formulas or is it possible to give the details?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top