Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Error in verify design:Latium Rule not checked,help!

Status
Not open for further replies.

edaboardman

Junior Member level 3
Joined
May 28, 2005
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,490
latium design rules exist

Error in verify design:Latium Rule not checked,help!
when I verify design-> clearence,there are 3 Clearence errors:

Location
(-990,266 L1)Latium Rule not checked
.......

explaination:
pin pair
differential diff pair rule
.......
and is one pin of a differential pair.

when I produce gerber files, there is nothing wrong with layer1, but there are 3 error with all layer of split/Mix plane.

why?
how to solve it?
Thanks!
 

amjad

Full Member level 5
Joined
Dec 29, 2002
Messages
273
Helped
9
Reputation
18
Reaction score
5
Trophy points
1,298
Activity points
2,291
latium rule

It occurs because some rules may be set for some components so just go to SETUP-->DESIGN RULES-->COMPONENT and select all components set all rules and then again select all components set them to default rule
 

edaboardman

Junior Member level 3
Joined
May 28, 2005
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,490
latium rule not checked diff pair

Thank you!
You meen I had to delete the rule set for the components?
Yes,this method work,but .....I have to rebuild the rules every time I CAM the PCB.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top