GabrielP
Newbie
Hello,
Sorry if this question seems dumb, but it's my first time using ADS. When I try to run the EM simulation for a microstrip coupler I get the error "Exit status: Done (job failed)", no other details:
The simulation in the schematic design works fine.
Does anyone have any idea what is the cause of this error?
Thanks!
Sorry if this question seems dumb, but it's my first time using ADS. When I try to run the EM simulation for a microstrip coupler I get the error "Exit status: Done (job failed)", no other details:
The simulation in the schematic design works fine.
Does anyone have any idea what is the cause of this error?
Thanks!