Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Equation to calculate microstrip feed line

Status
Not open for further replies.

ice.deepcold

Junior Member level 1
Joined
Jun 10, 2009
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,383
feed line equation

Hello,
Is there an equation to calculate the feed line of a rectangular microstrip path either for a 50 or 100 ohms.

thank you very much
 

Re: Microstrip feed line

here are two examples

chemandy.com/calculators/microstrip_transmission_line_calculator.htm
chemandy.com/calculators/microstrip_transmission_line_calculator_IPC_2141.htm
 

Re: Microstrip feed line

thanks
but I'm looking at something that has formulas and i want to calculate the width of the feed line not the square patch.


Thanks
 

Re: Microstrip feed line

ice.deepcold said:
thanks
but I'm looking at something that has formulas and i want to calculate the width of the feed line not the square patch.


Thanks
hi balanis antena theory book thay have give example problem
 
Re: Microstrip feed line

REally!
what frequency are u using for ur example?
 

Re: Microstrip feed line

ice.deepcold said:
REally!
what frequency are u using for ur example?
10GHz

Added after 4 minutes:

ice.deepcold said:
REally!
what frequency are u using for ur example?
how to find air gap width for a batch antenna feed any way?or formula or thump rule?
 

Re: Microstrip feed line

In what section of the balanis book is the formula to calculate the width of the feed line.

thank uuu
 

Microstrip feed line

Check Pozar's Microwave Engineering book, any edition.
 

Re: Microstrip feed line

ice.deepcold said:
In what section of the balanis book is the formula to calculate the width of the feed line.

thank uuu
chapter14
 

Hello Sundar,
I got the problem which you told in balanis. But how do u calculate g12? bcoz that is required or calculating the feed point.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top