Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

epicprog single layer design

Status
Not open for further replies.

nebisman

Full Member level 4
Joined
Apr 13, 2002
Messages
226
Helped
10
Reputation
22
Reaction score
9
Trophy points
1,298
Activity points
1,849
Uploaded again for those who write me
 

icprog propic software is lame

if you look at icprog

this app will allow that programmer too program most pics {most is 80+% of them}
but you need too add some soic sop etc sockets also on an adapters you can make up

the details are easy and new chips arent too hard too add as they will conform too one another algurithm

my advice is too forget the programmers own software

the older licence key gen dosnt work and produce a correct code
{from the same root as the author} this gives him the ability too shake off the keygen guys
and only then program 0000 0000 too the chip
when using win xp version {only one that runs from win xp}

however icprog dosnt suffer from this

details are avalible on the net too configure icprog too use the above programer

until the keygen is fixed ...!!! hint hint!!! then i recomend using icprog only....

as it runs perfect ....

and also

what a nice design of board well done

i made one on vero board

i did however make a epropic2 an epic and a propic in one

with icp and other sockets
but just using some plain sockets {cheep} and a plastic case


never let me down.....
 

Nice work

Nice work nebisman i agree with my friend why not ic prog at movment this is nice programmer and can support almost every hardware in the world i also upload a programmer pleasde check it

keep it up like these thing

regards
khalid
 

yes with the epicwin 2.41 beta, we can program mostl of microcontrollers, I upload other circuit for propic2 ICSP, that works with ICPROG. I like it too(ICPROG) friends.

thanks
nebisman
 

yes! i have some software,i post to
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top