Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

emulate virtual com port using usb driver wceusbsh.sys

Status
Not open for further replies.

KH

Junior Member level 1
Joined
Nov 1, 2004
Messages
16
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,281
Activity points
103
writing applications using wceusbsh.sys

Hi,

I am using a USB driver wceusbsh.sys to communicate with a device using USB. However, how can I emulata a virtual com port so that I can use Hyper Terminal to communicate with the device ?

Thanks.
 

newelltech

Full Member level 4
Joined
Aug 23, 2006
Messages
216
Helped
34
Reputation
68
Reaction score
2
Trophy points
1,298
Activity points
2,929
wceusbsh

I assume that you have a CE device and you are writing an application that talks to another device connected to the CE's USB port?
Do you want to run the Hyper-Terminal app on you CE device or run Hyper-Terminal on another PC that plugs into your CE device?
 

KH

Junior Member level 1
Joined
Nov 1, 2004
Messages
16
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,281
Activity points
103
wceusbsh.sys

Hi,

Yes, I have a CE device connected to a PC through USB.
I want to run HyperTerminal in the PC to communicate with the CE device.
Another point is that I'm not running any OS in my CE device, but in bootloader mode.

Basically the enumeration part is done.

Thanks.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top