HAIFA86
Newbie level 4
Hi,
I want to do the EMC simulation of a PCB with Hyperlynx
I chose a net between two ICs: a microcontroller without any digital peripherial and an analog IC(AD8361 et R8C/L38A).
I charged the ibis models of both of them, however when I simulate there is no signal.
Is the problem the fact that the signals between the two ICs are analog?
please Ireally need help.
thanks
I want to do the EMC simulation of a PCB with Hyperlynx
I chose a net between two ICs: a microcontroller without any digital peripherial and an analog IC(AD8361 et R8C/L38A).
I charged the ibis models of both of them, however when I simulate there is no signal.
Is the problem the fact that the signals between the two ICs are analog?
please Ireally need help.
thanks