EMC knowledge for PCB design

[davidwuf]

Hello All,
Does anyone have the document regarding to EMC knowledge?
Thank you all!

Regards,
Davidwuf

 

[cks3976]

Question not clear....if you are talking about good PCB design practices, refer Mark I Montrose : https://www.amazon.com/Emc-Printed-Circuit-Board-Design/dp/078034703X

 

[marce]

First Link Requires Login
EMC Information Centre

http://www.compliance-club.com/pdf/EMCTestingPart1.pdf
http://www.compliance-club.com/pdf/EMCTestingPart2.pdf
http://www.compliance-club.com/pdf/EMCTestingPart3.pdf
http://www.compliance-club.com/pdf/EMCTestingPart4.pdf
http://www.compliance-club.com/pdf/EMCTestingPart5.pdf
http://www.compliance-club.com/pdf/EMCTestingPart6.pdf
http://www.compliance-club.com/pdf/EMCTestingPart7.pdf
EMC Design
Design Techniques for EMC
Design Techniques for EMC: cables and connectors
EMC Compliance Club – Design Techniques for EMC. Part 3 — Filtering and Suppressing Transients.
Design Techniques for EMC - part 4
PCB DESIGN TECHNIQUES FOR LOWEST-COST EMC COMPLIANCE
Design for EMC Part 6: ESD, dips and dropouts, etc.


EMC Compliance Club – Design Techniques for EMC Part 0 Introduction & Part 1 - Circuit Design and Choice of Components (SECOND PART)
EMC Compliance Club – Design Techniques for EMC Part 2 — Cables and Connectors (first half of part 2)
EMC Compliance Club – Advanced PCB Design and Layout for EMC Part 6 - Transmission Lines - 3rd Part

---------- Post added at 13:05 ---------- Previous post was at 13:03 ----------

Oh forgot, get the definitive book on EMC:
EMC Books

This is the best source of EMC info, or Keith Armstrong from links in above post.