Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
basically, showing text on LCD from MikroC consist of two commands (if we talk about 2x16 char lcd).
Lcd_Init(&PORTB); //for example use port B as lcd output port
and
Lcd_Out(1, 1, "Test"); //output text on line 1 pos 1
In newer version of MikroC i think there is Lcd_Config instead of Lcd_Init where u can select all those other pins that are used to control LCD.
But i think that help in MikroC is very well written and can help you ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
