sedralabs
Newbie level 2
68hc908jk3
i'm using microcontroller motorola 68HC908JK3 in an HVAC applictaion
lately I faced a big problem regarding saving data on the flash during the run time program. I couldn’t emulate the flash as eeprom . I read the application note AN2183 and AN2346 and AN1831 they are very complicated and not well organized . in most of the other controllers like PIC and AVR there is an easy routine written in the datasheet of these controllers describes how you could use either their eeprom or flash .
So I’m asking you to send me any routine that I can use easily in jk3 to write about 10 bytes on the flash and then read them again[/b]
i'm using microcontroller motorola 68HC908JK3 in an HVAC applictaion
lately I faced a big problem regarding saving data on the flash during the run time program. I couldn’t emulate the flash as eeprom . I read the application note AN2183 and AN2346 and AN1831 they are very complicated and not well organized . in most of the other controllers like PIC and AVR there is an easy routine written in the datasheet of these controllers describes how you could use either their eeprom or flash .
So I’m asking you to send me any routine that I can use easily in jk3 to write about 10 bytes on the flash and then read them again[/b]