Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

EAGLE PRO : make a pin of a symbol belong to a certain net

Status
Not open for further replies.
T

treez

Guest
Is this possible?

Its because i have these net "signs" and need to ensure they are all connected to that net.....the net signs are made with a pad which has zero dimension....as its just a marker and not a component
 

I don't understand what you mean.

Pins which are defined as direction "PWR" will automatically connect to pins which have the same name even if you don't use an explicit net on the schematic.

Keith
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top