Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Eagle Pro....how to highlight nets that have become unrouted?

Status
Not open for further replies.
T

treez

Guest
Hello,

I have just been browsing over my Eagle PCB layout, and noticed to my horror, that a PCB trace has somehow become unrouted..........the PCB is so dense that i didnt notice till i happened to be zoomed in to a particular subcircuit area.

I have terrible fear that this may happen again.............how can i get Eagle to flag up and point out any unrouted traces to me?
 

If you do RATSNEST then it reports how many unrouted nets there are at the bottom of the screen so it is easy to check.

As for finding them, the easy way is to turn off all layers except 'unrouted'.

Keith
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top