Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Eagle pro....how to adjust dimension feature and stop it snapping to lines

Status
Not open for further replies.
T

treez

Guest
Newbie level 1
Hello,

The dimension tool is snapping unwantedly to lines...how do i stop this, and how do i make it smaller so i can take precision small measurements?
 

I am new to Eagle. On the top left corner of the screen right under "File" and the folder looking thingy, there is a dotted thing that if you land the cursor on it, it'll say "Grid". You go in and adjust the fineness of the grid to the precision you want. I don't know how to make it NOT snap to grid, I always want it to be on grid. The complain of Eagle is I cannot make the snapping grid finer than the display grid, which is very inconvenience. You have to make the grid to the snapping resolution.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
The snap length is set in "Options" "Set" "Misc" tab.

Keith
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top