u24c02
Advanced Member level 1
Hi
i have problem that it's seem like power.
*
When i working fx2lp board and fpga board.
So i connect with both board *for slave fifo working.
Fx2lp board is just connected USB cable( it's just use power from usb cable).
*
When i connect FPGA Board to Fx2lp board, FPGA Board's led is weak on.
it's seem like something wrong. but slave fifo is working well(stream project ).
*
I dont know what am i check ?
*
*if i use 16bit slavefifo mode, which pin used for i2c in fx2lp-56pin?
how can i handle of this problem?
i have problem that it's seem like power.
*
When i working fx2lp board and fpga board.
So i connect with both board *for slave fifo working.
Fx2lp board is just connected USB cable( it's just use power from usb cable).
*
When i connect FPGA Board to Fx2lp board, FPGA Board's led is weak on.
it's seem like something wrong. but slave fifo is working well(stream project ).
*
I dont know what am i check ?
*
*if i use 16bit slavefifo mode, which pin used for i2c in fx2lp-56pin?
how can i handle of this problem?