Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ds pic not working after changing the crystal settings

Status
Not open for further replies.

raman00084

Full Member level 6
Full Member level 6
Joined
Nov 29, 2010
Messages
375
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Visit site
Activity points
4,076
my ds pic 30f6010a is not working. at first when i soldered it worked, after changing the crystal settings in ccs ( i think i setted the wrong parameters) and burned using pickkit2 after that the chip is not detected in pickit2. kindly tel me the nature of the problem
is there any way to rework the chip?




regards
kalyan
 

yes i erased the chip but also my pic kit2 is not detecting the other dspic chips are working fine. my doubt is by setting the wrong crystal setting can the chip be spoiled ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top