Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Drive ILI9488 in SPI + RGB - Sequence

Status
Not open for further replies.

Roudoudou

Newbie level 1
Joined
Jun 14, 2007
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Aix-en-provence, France
Activity points
1,287
Hi Folks,

I use the ILI9488 connected to a Cortex M4 on SPI (3-wire) interface and a Cortex A5 on RGB interface. I need to configure the LCD Driver through SPI interface to allow Cortex A5 transferring data through RGB interface.
I found many example on https://en.lcdlcd.com/ website but without any success.

Does anyone have more details about the sequence to apply (by SPI) to configure the LCD in 18-bit RGB Mode ?

Regards
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top