Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

DRC Error on PCB Editor

Status
Not open for further replies.

tiwari.sachin

Full Member level 6
Joined
Aug 1, 2009
Messages
337
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Location
India
Activity points
4,416
Hello

Firstly i am using OrCAD 15.7 and designing the board using PCBEditor.

I have designed a board wherein i am getting a DRC error for the distance between two parts.

This is because i have placed these parts very close to eachother but on final board i am sure that it will not be a problem.

Now how can i rectify this. I know there has to be some setting for this. I tried changing spacing rule set but somehow i am unable to find the required option.

Attached picture shows the DRC Error that i am referring to.

Regards
Sachin
 

Attachments

  • DRC Error.JPG
    DRC Error.JPG
    91.4 KB · Views: 16

samym

Member level 4
Joined
Oct 7, 2010
Messages
77
Helped
13
Reputation
26
Reaction score
13
Trophy points
1,288
Location
india
Activity points
1,660
hi,

for finding part to part error first we need to give proper placebound top or bottom u can turn on this error in below way

colours-stackup-nonconductor-package top or bottom need to on drc in this
 

keith1200rs

Super Moderator
Staff member
Joined
Oct 9, 2009
Messages
10,877
Helped
2,064
Reputation
4,128
Reaction score
1,597
Trophy points
1,403
Location
Yorkshire, UK
Activity points
57,271
I would turn the offending part through 90 degrees which would also make the routing more logical!

Keith
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top