Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Doubts in allegro Tool.

Status
Not open for further replies.

vel_2

Newbie level 5
Joined
Sep 2, 2009
Messages
8
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
india
Activity points
1,324
Hi,

Is there are any shortcut metods to change the trace angle while doing the routing. Kindly let me know.

Thanks,
Vel.
 

soodamanikannan

Member level 5
Joined
Jul 16, 2010
Messages
82
Helped
4
Reputation
8
Reaction score
4
Trophy points
1,288
Location
Coimbatore
Activity points
1,704
Hi Vel_2,


During the routing see the option tab in this tab line lock option displayed three ways for trce bending method a)off b)45deg & c)90deg. you set a)off option you can route any angle.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top