Doing ripup on a trace in Allegro

[Leonard K]

I am new to Allegro and this very simple thing is frustrating me. I can't seem to find a way to do a simple thing like rip up a trace. Could someone tell me how to do this very simple thing? Using Allegro PCB Editor v15.5

Thanks,
- Leonard

 

[lhademmor]

Sorry but rip up ? Is it deleting You meen ? Then look after a red large X in the menu bar or under edit select delete.
In the findfilter choose all off and the cline segments on for line part or clines on for entire trace from "corner point to corner point" (eg via 2 via).

 

[Leonard K]

Thanks very much. The sequence was EDIT>DELETE, and then in FIND choose CLINE only, and then in OPTIONS specify RIPUP ETCH.

- Leonard K