manul place and route aint possible.. wot tool u have along with ISE 6.2,?
floor planner is there.. try to take a look at this.. if u place the cells components u can as well route it..
try it.. u wud have tools which does this place and route.
Yes.
you can try FPGA editor,you can manually place and route your trace.but it take too much time.
you can automatically palce & route first
and modify the trace or component(LUT, ...)manually
I have never used FPGA Editor manual routing, but I think I see how to get started.
First of all, be sure you are in read/write mode. File -> Main Properties -> General -> Edit Mode -> Read Write.
While holding down the CTRL key, select the desired path segments, and then click Tool -> Route -> Manual Route. It will route the net along your desired paths, or emit some sort of error message. If you don't select enough path segments, then the Manual Route menu item will be grayed out.
You can also use that manual routing technique to connect two previously unused component pins, but first you must go inside the component and attach those pins to some logic.
Manual Place and Route is not normally used as you specify the constraints and routing is done within that but if you feel that certain nets can be routed better after looking at them in the FPGA editor , you can unroute those nets in particular and manually re-route them. Do not use for full manula route.