Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Does current monitor gain (x10)appear in transfer function of buckBoost feedback loop

Status
Not open for further replies.
T

treez

Guest
Hello,
In the attached schematic (and LTspice simulation) of a buckboost converter, the LED current sense resistor voltage is multiplied by 10 by the Current monitor (LTC6101).
Should this factor of 10 appear in the small signal Error amplifier transfer function for the purposes of plotting out the Bode plots and assessing the gain and phase margin?
 

Attachments

  • bukboost.pdf
    33.1 KB · Views: 66
  • bukboost.txt
    9.6 KB · Views: 34
Last edited by a moderator:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top