T
treez
Guest
Hello,
In the attached schematic (and LTspice simulation) of a buckboost converter, the LED current sense resistor voltage is multiplied by 10 by the Current monitor (LTC6101).
Should this factor of 10 appear in the small signal Error amplifier transfer function for the purposes of plotting out the Bode plots and assessing the gain and phase margin?
In the attached schematic (and LTspice simulation) of a buckboost converter, the LED current sense resistor voltage is multiplied by 10 by the Current monitor (LTC6101).
Should this factor of 10 appear in the small signal Error amplifier transfer function for the purposes of plotting out the Bode plots and assessing the gain and phase margin?
Last edited by a moderator: