Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Do we need thermal reliefs for TO247 diode in 1oz copper plane?

Status
Not open for further replies.

cupoftea

Advanced Member level 5
Advanced Member level 5
Joined
Jun 13, 2021
Messages
2,974
Helped
59
Reputation
118
Reaction score
137
Trophy points
63
Activity points
15,766
Hi,
How little thermal reliefing can you get away with with a to247 Diode?
The attached is a TO247 diode (three pics at different zoom in levels) connecting to a ground plane of 1oz copper as pointed out.
(PCB screen grid id 1mm)
Can we just use an 80W soldering iron and not even bother with the thermal relief?...this isnt for production..just single prototype.
 

Attachments

  • Thermal reliefs_ shot.jpg
    Thermal reliefs_ shot.jpg
    641.8 KB · Views: 203
  • Thermal reliefs_close up shot.jpg
    Thermal reliefs_close up shot.jpg
    227.4 KB · Views: 214
  • Thermal reliefs_wide shot.jpg
    Thermal reliefs_wide shot.jpg
    397.5 KB · Views: 213
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top