Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Distribution Transformer (Pole Mounted) Wiring

Status
Not open for further replies.

infinite_gbps

Member level 3
Joined
May 11, 2009
Messages
59
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,804
I have a question regarding distribution transformer mounted on a pole (neighborhood), how are more than one house wired to a distribution transformer on the pole? Are they all connected to the 3 wire terminals?

Some details on this would be great. Links are welcome.
 

Yes they are connected in parallel.

Transformers are autotransformer configuration. Secondary (for U.S. based) are 240 vac center tapped. Center tap is neutral with 120 vac to either end. Called split phase system. Primary side voltage depends on particular installation, typically 12 kV but can range from 7 kV to 25 kV.
 

it depends on single phase connection or three phase connection required for the home.
single phase ( 1 phase & neutral) normal for the homes
3 phase (3 phase lines & neutral)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top